Sparepart Boiler Gestra Blowdown Valve

Sparepart Boiler Gestra Blowdown Valve
Get Best Offer
Gestra blowdown valve is produced with high quality, resulting in maximum boiler safety and long-term operating time. This type of valve functions to control the concentration of solids / total dissolved (TDS) in the boiler. We offer Gestra blowdown valve with the following types.
Brand :

Gestra

Category :

Boiler Parts

Share :

Distributor Sparepart Boiler Gestra Blowdown Valve

Gestra blowdown valve is produced with high quality, resulting in maximum boiler safety and long-term operating time. This type of valve functions to control the concentration of solids / total dissolved (TDS) in the boiler. We offer Gestra blowdown valve with the following types. This briefly produces "vacuum" at the bottom of the boiler. The resulting suction removes settled sediment on the floor of the boiler, also known as boiler sludge, from the boiler. The blowdown action is only effective for the first two seconds. Longer opening times lead to water losses. The boiler pressure supports the closing force of the MPA valve spring, so that the valve closes reliably. The primary area of use is steam boiler plants. The intermittent blowdown action of the valves is triggered by controls such as the TA 7, for example. The control consists of an electronic cycling timer, a three-way solenoid valve and a strainer. When the intermittent blowdown valve opens, the large cross-sectional area of the orifice creates a suction effect, giving a short-term high water flow which will discharge the precipitated sludge and sediments. Type PA valves are intended for manual operation. For the blowdown process, the valve is opened fully by hand with the lever for around two to three seconds. The spring-loaded valve cone is forced out of the valve seat. As a result, accumulated sludge and sediments rush out of the open valve. When the manual lever is slowly released the spring forces the valve cone back into the valve seat and the valve is closed rapidly. Type MPA valves are equipped with a diaphragm actuator for automatic operation. Compressed air or pressurised water is used as the control fluid. The diaphragm actuator opens the intermittent blowdown valve to perform a brief blowdown.

Type

Rapid-Action Intermittent Blowdown Valve - 

    GESTRA Blowdown Valve PA 46, PN 40 / CLASS 150 / 300, DN 20-50
    GESTRA Blowdown Valve PA 47, PN 63 / CLASS 600, DN 25, 40, 50
    GESTRA Blowdown Valve PA 48, PN 100 / CLASS 600, DN 25, 40, 50
    GESTRA Blowdown Valve MPA 46, PN 40 / CLASS 150 / 300, DN 20-50
    GESTRA Blowdown Valve MPA 47, PN 63 / CLASS 600, DN 25, 40, 50
    GESTRA Blowdown Valve MPA 48, PN 100 / CLASS 600, DN 25, 40, 50

Programme-Controlled Blowdown System - 

    Gestra Automatic Intermittent Blowdown Control TA 7

Fitur

    Rapid-Action Intermittent Blowdown Valve PA 47 – manual operation
    Rapid-Action Intermittent Blowdown Valve MPA 47 with diaphragm actuator
    Hand lever with clip fastener
    Separate pretensioning
    Wear-protection by downstream, integrated radial assembly level cone
    Tell-tale hole inside the protection pipe
    Leakage control
    Assembly kit 335130 for retrofitting the actuator of an existing MPA 26 or MPA 27 in a PA 46 or PA 47 to upgrade them to an MPA 46 or MPA 47 (guide bushing with washer and spacer disc).
    Diaphragm actuator 337866 for PA 4x (diaphragm actuator, spacer disc).
    TA program controller for MPA 4x n Retrofit kit 337980 containing proximity switch for MPA 4x (one limit switch).
    Retrofit kit 337946 containing proximity switch for MPA 4x (two limit switches).
    Emergency lever 337867 for MPA 46/47 and 338073 for MPA 48.
    The cycling timer PRS 8 is mounted in an appliance plug socket fitted on the three-way solenoid valve.

Popular Tags :

Aquametro | Ari Armaturen | Asahi | Beru | Condor | Danfoss | DelVal | Dungs |