Suntec oil pump type AT3 gear size 45 55 65

Indotama Niaga Teknik offers products from suntec, namely the suntec oil pump type AT3 gear size 45 55 65, as a distributor of burner spare parts in Indonesia we offer a variety of industrial and manufacturing needs
Brand :

Suntec

Category :

Burner Parts

Share :

Distributor Suntec oil pump type AT3 gear size 45 55 65

Suntec oil pump type AT3 gear size 45 55 65

Suntec oil pump type AT3 gear size 45 55 65 offers 2 mode pressure operation, in-line cut-off function, plus a special hydraulic outlet on the cover featuring nozzle pressure during high mode and dumping during low mode

APPLICATIONS

  • Light oil and B10 heating oil/biofuel blend (as defined in DIN V51603-6).
  • Two firing rates (with a sole nozzle line).
  • Hydraulic requirement in high mode only.
  • One or two-pipe system.

PUMP OPERATING PRINCIPLE 

The gear set draws oil from the tank through the built-in filter and transfers it to the nozzle line via the cut-off solenoid valve. Pressure regulation is assured by two spool valves, one for each pressure mode.Switching between low and high pressure is assured by a "normally open" by-pass solenoid valve. When this solenoid is non-activated, a by-pass channel is open, allowing the normal functioning of the low pressure valve which sets the nozzle pressure. When this solenoid is activated, the by-pass channel is closed, thus pressure will build up on both sides of the low pressure valve eliminating its effect, and the high pressure valve now determines the nozzle pressure.The blocking solenoid valve of the nozzle line is of the "normally closed" type.This design ensures extremely fast response and the switching can be selected according to the burner operating sequence and is independent of motor speed.When this solenoid is non-activated, the valve is closed and all oil pressurized by the gear set passes through the regulators to suction or to the return line, depending upon pipe arrangement.As soon as this solenoid is activated, oil passes to the nozzle line at the pressure set by the pressure regulating valves.In two pipe operation, the by-pass plug must be fitted in the return port, which ensures that the oil dumped by the regulating valves is returned to the tank and the suction line flow is equal to the gear set capacity. Bleeding in two pipe operation is automatic (it is assured by a bleed flat on the pistons), but it may be accelerated by opening a pressure port.In one pipe operation, the by-pass plug must be removed, and the return plugged. Oil which is not required at the nozzle is returned directly to the gear inlet via the pressure regulating valves, and the suction line flow is equal to the nozzle flow.A pressure port must be opened to bleed the system.

Type

AT3 gear size 45 55 65

Fitur

-